![]() ![]() The remote control model is MR1SD25, I tried with the updated firmware and downgrading it but nothing changes. ", in the bottom center flash symbols of non-coupling between two devices, if I go to "." -> commands-> "connect drone" it tells me "remote control not connected". I manually open the app, I go to "connect the drone", I choose "mavic mini", on the screen appears the instructions for preparing and turning on the remote control, I go to the camera view and a red writing appears at the top left "Remote control not con. If I connect them with the cable supplied and turn on the remote control, the DJI Fly app does not open on its own, the smartphone start to charge. I think the problem is in the coupling between the smartphone and the remote control. I received the Mavic Mini a few days ago but I have never been able to use it. Hi guys, I think I have a problem smilar to yours. if either the drone or the controller is a replacement, are they, by any chance, from differing regions and maybe incompatible with one another? I believe there are at least two models of controller but I do not know if there are corresponding models of Mavic Mini. The only other thing I can think of and I do not know that it is a valid concern, is. I would ask what made it necessary to link the controller to the drone in the first place?Īssuming you can not link the controller and drone via the App then I'd suggest trying to link the controller to a known to be working Mavic Mini and your Mavic Mini to a known, to be working controller to establish whether it is the controller or drone at fault or both. ![]() ![]() Given that phone works with your controller you could try linking the drone and the controller using the App but that is "clutching at straws" as I don't know why one method would work and the other not. When you tried that did both the controller and the drone give you the charge LEDs lighting in sequence thing as shown in ? But the next step, pairing with the drone, fails. Understand me correct: The connection between my phone and the RC controller works. Thanks for the advice, but this doesn't help neither. If it will not allow file transfers then you may have a dodgy cable and or a dodgy socket on the A40. If I am correct and if you are having problems connecting the A40 to the controller then I'd suggest checking if the cable will connect the A40 to a computer and allow file transfers between the A40 and the computer. As far as I know the connection between the controller and viewing device is cable only. They should link with one another quite quickly.ĭoing this I have just swapped controllers on my mini and then back again and this was without having the phone connected. Switch both the controller and drone on, once they have booted press-and-keep-pressed the power button on the controller until the charge level leds start flashing in sequence (it may take some time) then do the same on the drone. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |